Release A
THALES LPOS
THALES POST-L-0H-10 USER GUIDE
THALES Document 10/13
III.4) Signal Cables quality
Use shielded signal cables to ensure that the appropriate electromagnetic compatibility
classification is maintained for the intended environment.
III.5) Static Electricity
Static electricity can destroy electronic components inside the computer. To prevent static
damage, discharge static electricity from your body before you touch any of the computer’s
electronic components, such as a memory module. You can do so by touching an unpainted
metal surface on the computer’s input/output panel.
Handle components with care. Hold a component such as a memory module by its edges, not
its pins.
III.6) General Instructions
III.6.a)
WHEN USING THE TERMINAL
Protect the computer from environmental hazards as dirt, dust, food, liquids, temperature
extremes and over exposure to sunlight.
When the computer is moved between two environments with very different temperature
and/or humidity ranges, condensation may form on or within the computer. To avoid
damaging the terminal, allow sufficient time for the moisture to evaporate before using the
terminal.
When taking the terminal from low-temperature conditions into a warmer environment or
from high-temperature conditions into a cooler environment, allow the computer to acclimate
to room temperature before turning on power.
When you disconnect a cable, pull on its connector or on its strain-relief loop, not on the cable
itself. As you pull out the connector, keep it evenly aligned to avoid bending any connector
pins. Also, before you connect a cable make sure that both connectors are correctly oriented
and aligned.
III.6.b)
IF YOUR TERMINAL GETS WET
If the terminal is connected to an electric outlet, it is recommended to turn off AC power at
the circuit breaker before attempting to remove the power cables from the electrical outlet.
Use the utmost caution when removing wet cables from a live power source.
Do not use artificial means such as hair dryer or a fan to speed the drying process.
To help prevent electrical shock, verify that the computer is thoroughly dry before continuing
to work
III.7) When working inside the terminal
.
Before performing maintenance inside or outside the terminal, wait at least 5 seconds after
turning off the computer before disconnecting an external device (peripheral), removing or
changing a memory module or an add-on card, to help prevent possible damage to the main
board.
