Engine Start/Stop Button and Safety Lanyard
Make sure that both switches operate properly. Start engine and stop it using each switch individually.
Throttle
Steering System For jetKayak
Armpole for jetSurf
CAUTION:
Damage to the Armpole, Armpole housing and/or the handle can result in SEVERE INJURY OR DEATH.
Exhaust Pipe Cooling
CAUTION
CAUTION
CAUTION
CAUTION
18
To ensure it is properly working, check by-pass outlet. Water mist/drops should come out exhaust
by-pass outlet. If the exhaust from the by-pass is not wet, stop engine and consult your Aquanami
Dealer.
Never run the engine without supplying water to the exhaust cooling system when watercraft is out of
water. If out of water, level the craft. Install a garden hose to the flushing connector. Refer to POST-
OPERATION CARE and follow the procedure.
Failure to flush exhaust cooling system, when engine is out of water, may severely damage the
Never run engine longer than 1 minute when watercraft is out of water. Drive line seal has no cooling
when watercraft is out of water.
•The exhaust pipe is cooled by the water from the jet pump. If the water flow from jet pump to
exhaust pipe is blocked, the exhaust pipe and connecting components could be damaged.
•Close and tight the exhaust flush cap (garden hose connector cap) after flushing exhaust system.
•Exhaust system will be burned, damaged or caught fire if the exhaust flush cap left open!
Lanyard could be securely attached to the kill switch post. It shuts electric system and engine off
when being pulled off its post.
Check the throttle lever for free and smooth operation. It should return to its initial position
immediately after it is released.
Armpole provides support to operator during operation. It also houses control cables and electric
wires. Having a damage free and fully functioning Armpole is important to your safety as well as other
waterway users.
Check the Armpole housing looking for cuts, tears or any other kind of damage. Ensure that the
Armpole housing is securely connected to the housing anchor and the handle. The Armpole should
remain securely attached to the jetSurf when the handle is pulled. Additionally ensure that there are
no loose and/or missing screws.
WARNING
WARNING
WARNING
WARNING
•Should the stop/start button not work properly, refer to an authorized Aquanami dealer immediately.
Fail to do so may result in SEVERE INJURY OR DEATH.
•Should the safety lanyard be loose or not work properly, replace it immediately in order to avoid
unsafe use.
Check throttle lever operation before starting the engine.
check steering operation for free movement with the assistance of another person. When the steering
handle is in the center position, the jet pump nozzle should be in the straight ahead position. Ensure
the jet pump nozzle pivot easily.
•Check steering handle and corresponding steering nozzle operation before starting the engine.
•Never turn steering handle while someone is nearby the rear of the watercraft. Keep away from
steering moving parts.
WARNING
!
!
!
!
!