54
3-5 FUEL REED CIRCUIT
3-5-1 Carburetor
Disassemble all carburetor components, clean
them with solvent, then dry them with
compresses air.
Pay special attention to the ducts in carburetor
body.
Carefully check the condition of all components.
The needle may be worn, replace it.
The throttle must slide free in the carburetor.
If there is excessive play due to wear the
throttle must be replaced.
Using the new gaskets when reassembling the
carburetor.
Inspect if the pressure piston is worn or
presents notches, Inspect the vacuum
membrane carefully.
Damaged or cut are not allowed.
3-5-2 How to take off the carburetor
-Remove the fuel feed pipes.
-Remove the automatic by choke connector.
-Loosen the throttle control cable adjusting nut
and disconnect the throttle control cable from
the carburetor.
-Loosen the air filter fastening strap and
remove the carburetor.
