TFT Extend-A-Gun VP, Instruction For Safe Installation, Operation, And Maintenance

Page: 17 / 28

©Copyright Task Force Tips LLC 2021 17 LIX-575 June 24, 2021 Rev00
8.0 INSTALLATION INSTRUCTIONS
8.1 WATERWAY INSTALLATION
1. Install the mounting brackets according to structural requirements (see section 5.0) and (see section 6.0) .
2. Install the top deck, with clearance hole(s) for the telescoping waterway and reed switch wiring per Figure 7.4.
3. Loosen the set screw on the deck plate of the telescoping waterway. This will allow the plate to rotate freely, since the correct
orientation cannot be determined until the valve is installed.
4. Install the telescoping waterway through the clearance hole, keeping the reed switch wiring above the deck.
5. Install the U-bolts in the mounting brackets and torque the nuts per Section 6.0, which varies by bracket type.
8.2 VALVE CONFIGURATION
Figure 8.2A
Figure 8.2B
4X GEARBOX
MOUNTING
SCREWS
RETAINING RING
SPROCKET
SOLENOID BRACKET
REED SWITCH
INLET ADAPTER
(ALWAYS INSTALLED
IN PORT 'A')
2X BLIND
PLUGS
REFERENCE ARROW
POINTS TOWARDS
PORT LETTER
PORT LETTERS
(A THRU D)
4X PLUG SCREWS 2X TRAVEL STOP SCREWS
TRUNNION ARROW
SCREW HOLE
NUMBERS
(1 THRU 7)
GEARBOX FEMALE THREADS OF VALVE;
TO TELESCOPING WATERWAY
RETAINING
RING
SPROCKET
GEARBOX
O-RING
BUSHING A
SHAFT
KEY KEY
O-RING
BUSHING B
RETAINING
RING
SOLENOID
BRACKET
THRUST
WASHER
SCREWS (3X)
STANDARD SHAFT POSITION
ALTERNATE SHAFT POSITION