©Copyright Task Force Tips LLC 2021
15
LIX-575 June 24, 2021 Rev00
7.4 ABOVE DECK CLEARANCE
Figure 7.4 shows a template for the clearance holes through the deck of the truck. A deck plate surrounding the outer tube of the
telescoping waterway is intended to neatly cover the holes. The hole shape is not critical, provided it is not smaller than the circles
shown and not larger than the perimeter of the deck plate.
Figure 7.4
7.5 BELOW DECK CLEARANCE
When determining the locations of the mounting brackets shown
, it is critical to verify adequate clearance for the deck
plate and pneumatic cylinder. It is also critical to verify clearance for the swing radius of the valve, which must be spun onto a threaded
connection during installation. Ideally the valve will be remain fully assembled for a 7.2” swing radius if there is adequate clearance,
however it is possible to temporarily remove the gearbox and Victaulic inlet for a reduced 5.0” swing radius. These swing radius values
apply regardless of the orientation of the inlet and gearbox.
3.75"
2X
2.375"
2X
1.50"
CUT EITHER A OR B
2.50"
2X CUT
5.00"
5.80"
PLATE
WIDTH
10.45" PLATE LENGTH
A
B
HOLE FOR PNEUMATIC
CYLINDER AND
REED SWITCH WIRING
HOLE FOR
WATERWAY
HOLES FOR
PNEUMATIC
PLUMBING