If the tower icon flashes, but does not set the time or the DCFtower does not appear at all, then please take note of the
following:
•
Recommended distance to any interfering sources like computer monitors or TV sets is a minimum of 1.5 - 2
meters.
•
Within ferro-concrete rooms (basements, superstructures), the received signal is naturally weakened. In extreme
cases, please place the unit close to a window and/ or point its front or back towards the Frankfurt transmitter.
•
During nighttime, the atmospheric disturbances are usually less severe - the reception is possible in most cases.
MANUAL TIME SETTING:
In case the Weather Station is not able to detect the DCF-signal (disturbances, transmitting distance, etc.), the time can
be manually set. The clock will then work as a normal Quartz clock:
1.
Press the SET key for around 3 seconds until the time display flashes.
2.
Use the + key to set the hours.
3.
Press again the SET key to switch to the minutes. Use the + key to set the minutes.
4.
Either press the SET key once more to exit the time set mode or do not touch any buttons for around 8 seconds
to confirm the set time.
Note:
The unit will still try to receive the signal every hour despite it being manually set. When it does receive the signal, it will
change the manually set time into the received time. During reception attempts the DCF tower icon will flash. If
reception has been unsuccessful, then the DCF tower icon will not appear but reception will still be attempted the
following hour.
LCD 3 INDOOR TEMPERATURE AND HUMIDITY:
The indoor temperature and humidity are measured and displayed on the third section of the LCD.
Note:
The MAX and MIN icons apply to the indoor temperature only.
TOGGLING AND RESETTING THE INDOOR RECORDINGS:
1.
To toggle between the indoor current, maximum and minimum
temperature
press the
MIN/MAX
key:
Once to show the maximum
temperature
Twice to show the minimum
temperature
Three times to return to the current
temperature
2.
To reset the minimum and maximum
temperature data
, press the MIN/MAX key continuously for about 2
seconds. This will reset the minimum and maximum data recorded to the
current temperature
.
POSITIONING THE WEATHER STATION:
The Weather Station comes attached with a removable table stand, which provides the option of table
standing or wall mounting the unit. To wall mount:
1.
Fix a screw (not supplied) into the desired wall, leaving the head extended out by about 5mm.
2.
Remove the stand from the Weather Station by pulling it away from the base and hang the
station onto the screw. Remember to ensure that it locks into place before releasing .
Indoor temperature in ºC
Minutes (flashing)
Hour (flashing)
Indoor humidity in %RH
MAX icon MIN icon
