4
Annual Service
•
Every 500,000 cycles the tool should be completely dismantled and new components should be used
where worn, damaged or recommended. All ‘O’ rings and seals should be renewed and lubricated with
MolyKote 111 grease before assembling.
•
For an easy complete service, Textron Fastening Systems offer a complete service kit as detailed below.
Spanners are specified in inches and across flats unless otherwise stated
A N N U A L / 5 0 0 , 0 0 0 C Y C L E S E R V I C E
Service Kit: 71600-99990
Part No.
Description
07900-00006
Spatular
07900-00008
7
/
16
x
1
/
2
Spanner
07900-00012
9
/
16
x
5
/
8
Spanner
07900-00015
5
/
8
x
11
/
16
Spanner
07900-00243
Screwdriver - Small
07900-00333
Screwdriver - Medium
07900-00469
2.5mm Allen Key
07900-00737
Piston Seal Sleeve
07900-00738
Piston Seal Tool
07900-00739
Piston Bullet
07900-00740
Cylinder Collar
07900-00741
Guide Tube
07900-00742
Insertion Rod
07900-00743
End Cap Assembly Tool
Part No.
Description
07900-00748
Threaded Sleeve Bullet
07900-00747
Valve Seat Tool
07900-00749
Threaded Sleeve Tool
07900-00750
Valve Needle Sleeve
07900-00751
3mm Allen Key - Short Reach
07900-00753
Circlip Pliers - Small
07900-00754
Priming Pump
07900-00755
Grease - MolyKote 111 - 100g tube
07900-00756
Loctite
®
243 Threadlocker
07900-00757
Scalpel
07900-00760
Pozi Screwdriver
07900-00788
Service Kit Storage Case
07900-00768
Reservoir Bullet
07900-00769
Trigger Tool
07992-00020
Grease - Moly-Lithium
Before dismantling:
•
Disconnect the battery before any servicing or dismantling is attempted, unless specifically instructed otherwise.
•
Care must be taken at all times to ensure that conditions are clean so that no foreign matter enters the tool or serious
damage may result.
•
Empty the oil from the tool following the first three steps of the priming procedure. Refer to the priming procedure on pages 14
and 15 of the Instruction Manual.
•
Remove the nose equipment.
For a complete service of the tool, we advise that you proceed with dismantling of sub-assemblies in the order shown on
page 5. After dismantling the tool we recommend that you replace all seals.
On reassembly it is essential to prime the tool and fit an appropriate nose assembly prior to operating.
