Textron ST480, Owner'S Manual & Service Manual

Page: 26 / 128

OPERATION AND SERVICE INFORMATION
3-18
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
perature range. (P/N 75500-G01)
• White Lithium Grease designed to provide lubrication protection in
areas where staining or discoloring is a problem, or in areas of
extreme temperature ranges. (P/N 75502-G01)
• Penetrant/Lubricant, a 4-in-1 product that penetrates seized parts,
lubricates leaving a light lubricating film, reduces corrosion by
adhering to wet or dry surfaces and displaces moisture, sealing
against future moisture return. (P/N 75503-G01)
• Multi-purpose Cleaner and Degreaser that contains natural, envi-
ronmentally safe solvents. (P/N 75504-G01)
• Multi-purpose Hand Cleaner is an industrial strength cleaner con-
taining no harsh solvents, yet gently lifts grease off hands. May be
used with or without water. (P/N 75505-G01)
• Battery Cleaner that neutralizes battery acids and dissolves termi-
nal corrosion and can be rinsed with water. (P/N 75506-G01)
• Biodegradable Cleaner that breaks down grease to be easily
wiped or rinsed away. (P/N 75507-G01)
• Multi-purpose Value Pack sampler includes 4 ounce (118 ml)
aerosol cans of Battery Protector, Penetrant/Lubricant, White Lith-
ium Grease, and Carburetor and Choke Cleaner. (P/N 75508-
G01)
• Plexus
®
plastic cleaner and polish removes minor scratches from
windshield. (P/N 28433-G**)
REPAIR
LIFTING THE VEHICLE
Tool List Qty. Required
Floor jack ...............................................................................1
Jack stands............................................................................4
Chocks...................................................................................4
To prevent possible injury or death
resulting from a vehicle falling from
a jack, be sure the vehicle is on a
firm and level surface. Never get under a vehicle while it is
supported by a jack. Use jack stands and test the stability of
the vehicle on the stands. Always place chocks in front and
behind the wheels not being raised. Use extreme care since
the vehicle is extremely unstable during the lifting process.
Some servicing operations may require the rear wheels or the entire
vehicle be raised.
Install chocks in front and behind each front wheel (Ref Fig. 16 on page
3-19). Center jack under rear bumper. Raise vehicle and locate a jack
stand under the outer end of each rear axle.
Lower jack and test the stability of the vehicle on the two jack stands.
Place the jack at the center of the front axle. Raise the vehicle and posi-
tion jack stands under the frame crossmember as indicated.
Lower jack and test the stability of vehicle on the four jack stands.
If only front or rear of vehicle is to be raised, place the chocks in front
and behind each wheel not being raised in order to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
! !