5 SETUP
6
5
SETUP
Unless otherwise noted, the information in the following
sections applies to both Lawnaire IV and V models.
5.1
UNPACKING THE AERATOR
Unpacking the aerator entails securing the handle and
rolling the unit off the shipping pallet.
WARNING
!
Banding is under tension and may snap back
when cut. Wear eye protection and stay clear
when cutting the band.
FOR ALL MODELS
1.
Cut the banding securing the aerator to the pallet.
2.
Unfold the handle by pulling on the transport lift
handle. See Figure 2.
1
Figure 2
1. Transport Lift Handle
FOR LAWNAIRE V MODELS
1.
Bolt the handle in place, as shown in Figure 3.
Figure 3
2.
Pull up on the transport lift handle to raise the aerator
to the transport position. See Figure 8. Carefully roll
the unit off the pallet.
FOR LAWNAIRE IV MODELS
1.
Flip the handle locking knobs up into position over
the handle bracket and tighten. HAND TIGHTEN
ONLY! See Figure 4.
1
1
Figure 4
1. Handle Locking Knobs
2.
Pull up on the transport lift handle to raise the aerator
to the transport position. See Figure 8. Carefully roll
the unit off the pallet.
NOTE: If the folding handle will not be used, bolt the
handle in place. See instructions in the
preceding section,
For Lawnaire V Models.
5.2
CHECKING THE CLUTCH CABLE
The clutch cable is adjusted prior to shipping; however, it
should be checked before the unit is put into service.
