5
1.5 DRIVEN ASSEMBLY TO REEL______________________________________________________________________
1.
Turn quick height adjusters knob
(S)
90° to unlock the
height adjustment for ease of assembly.
2.
Apply Lubriplate Multi-Lube compound to the outside
diameter of the bearing housing.
3.
Align the blade assembly
(C)
and the roller assembly
(D)
with their corresponding mounting locations on the driven
assembly
(A)
. Slide driven assembly onto bearing
housing, blade assembly and roller.
a.
Secure blade assembly with one 3/8-16 x 7/8” socket
head screw
(Q)
and lockwasher
(R)
.
b.
Loosely assemble nut
(W)
to driven end of roller. Do
not tighten.Thread nut
(AJ)
as far as possible onto
shaft.
4.
Assemble spacer block
(X)
with one 5/16-18 x 2-1/2”
carriage bolt, spacer, lockwasher and nut
(Y)
. Do not
tighten hardware. Be sure to install correct number of
shim washers
(N)
(Determined in
Section 1.2
).
Figure 10
1.6 CLUTCH ASSEMBLY _____________________________________________________________________________
1.
Loosen eccentric retaining screw
(AA)
and turn eccentric
nut
(AB)
to move blade assembly pulley
(AC)
towards
reel shaft as much as possible.
2.
22” Groomer:
Obtain drive pulley
(J)
from bag of parts
and place belt
(P)
on the pulley.
2.
18” Groomer:
Obtain spacer
(AD)
from bag of parts and
slide onto reel shaft. Place belt
(P)
on pulley assembly
(I)
.
NOTE:
To prevent permanent damage to the belt, do not
overtighten, twist, fold or bend the belt.
3.
22” Groomer:
Position drive pulley
(J)
with bearing
towards center of reel and slide the pulley onto the reel shaft.
As you slide the pulley down the shaft, work belt over blade
assembly pulley
(AC)
.
3.
18” Groomer:
Install key
(AE)
onto reel shaft. Align
pulley assembly
(I)
with key and slide onto the reel shaft.
As you slide the pulley down the shaft, work belt over
blade assembly pulley
(AC)
.
4.
22” Groomer:
Install spacer
(AD)
and key
(AE)
onto reel
shaft.
5.
22” Groomer:
Hold clutch
(E)
together and remove
shipping nut
(AF)
.
NOTE:
The clutch assembly
(E)
is spring loaded and must be
held together before you remove shipping nut
(AF)
to
prevent the clutch from coming apart.
6.
22” Groomer:
Align clutch
(E)
with key
(AE)
on reel shaft
and install clutch on the shaft. Secure by tightening bolt
(AG)
. Block the reel with a piece of wood and torque bolt
(AG)
to 20 ft lb (27 Nm).
7.
18” Groomer:
Secure pulley assembly to reel shaft with
3/8” hardware
(H)
. Block the reel with a piece of wood
and torque bolt to 20 ft lb (27 Nm).
Figure 11
Figure 12
Rotate 90°
S
Q
R
W
AJ
X
Y
Y
N
C
D
A
AA
AB
AC
J / I
P
Q
AC
J
P
AD
AE
AF
AG
E
AE AD
H
I
