5
RENOVAIRE
SERVICE / SPECIFICATIONS
SERVICE
When replacing any bolt, screw or other
fastener, use only original equipment parts or
parts of equivalent strength and material to
prevent possible failure.
1. Thoroughly clean all tines inside and out when
aerating is completed. A light coat of oil will
prevent rust and insure proper coring and slicing
the next time unit is put into service.
LUBRICATION
1. Wipe off grease fittings before and after
greasing.
2. Grease aerating wheel bearings as required.
TRANSPORT WHEELS
1. Check daily
2. Repack with grease yearly.
3. Air pressure: MINIMUM 45 p.s.i.
MAXIMUM 65 p.s.i.
SPECIFICATIONS
Chassis:
..................................... 2" extra strong pipe
Hitch:
.....................Clevis type with 3/4" diameter pin
Axles:
..................................Aerating: 1-1/4" diameter
Transporting: 3/4" diameter bolted to frame
Wheels:
.....Aerating: 12 cast iron wheels w/bushings
Transporting: Pneumatic 4.80 x 4.00-8, 6
ply
w/roller bearings
Net Weight:
......................... Approximately 1000 lbs.
Dimensions:
Width:
........................................................................8'
Transport Height:
...... ...........................................30"
Length:
........................................................................9'
Operating Speed:
.................................Up to 10 mph
Transport Speed:
.................................Up to 10 mph
Aerating Width:
.......................................................6'
Aerating Depth:
............................................Up to 5"
Aerating Pattern:
....................Approximately 6" x 6"
Hydraulic Lift:
........Raise and lower aerating wheels
Hydraulic Cylinder:
...........2-1/2" bore with 8" stroke
rated @ 3000 p.s.i.
Lubrication:
..........................Pressure grease fittings
