Greenlee / A Textron Company
6
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
HK520 Hydraulic Cable Cutter
Maintenance
Blade Sharpening Instructions
1.
Set blade on flat surface with
beveled edge facing down
(see Figure A)
2.
Use a sharpening stone to
remove all burrs from back
surface.
3.
Use a high-speed dremel-
type tool to flatten top edge
of blade (approximately
1/32" wide flat).
Do not leave a sharp edge.
This will cause chipping of
cutting surface and will
decrease blade life.
Use a spray lubricant to keep the cutting head free of
grit, dirt and metal chips.
Figure A
Flatten this surface.
Edge should be flat
BACK SIDE
FRONT SIDE
Beveled Edge
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection can
result in serious eye injury from
flying debris or hydraulic oil.
Do not perform any service or maintenance other
than as described in this manual. Injury or damage
to the tool may result.