Battery-powered In-line Cutters
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
10
Operation
(cont’d)
Cutting Procedure—ESG25L
1. Lift the head latch to open the cutter.
2. Place the material to be cut between the jaws.
3. Close the head latch completely.
4. Align the material at a 90° angle to the blades.
5. Pull the trigger to make the cut.
6. Hold the trigger down until the cutting tool achieves
pressure relief, which is accompanied by an audible
“pop”.
7. The cutting tool returns automatically.
Note: If it is necessary to retract the ram before a
cutting cycle is completed, push the retract button.
Pushing the retract button will result in the complete
retraction of the ram.
Head Latch
Cutting Head
Cutting Blade
Sharpening the Blade—ESG25L
1. Set blade on flat surface
with beveled edge facing
down (Figure A)
2. Use a sharpening stone to
remove all burrs from back
surface.
3. Use a high-speed dremel-
type tool to flatten top edge
of blade (approximately
1/32" wide flat).
Do not leave a sharp edge.
This will cause chipping
of cutting surface and will
decrease blade life.
Figure A
Flatten this surface.
Edge should be flat
BACK SIDE
FRONT SIDE
Beveled Edge
