EK425LT and EK425LX Battery-powered Crimping Tools
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
7
Operation
(cont’d)
Pressure Sensor
This tool is equipped with a pressure sensor that alerts
the user of an incomplete crimp.
• If the tool is manually retracted before completion of a
crimp, the red LED and an audible beep will be active
for 2 seconds.
• If the tool is unable to reach the required crimp force,
the red LED, work light, and an audible beep will pulse
until after the trigger is released.
Die Selection
Interchangeable dies may be used in the standard die
opening. Dies that may be used include:
• Greenlee KD6 series
• Burndy W and X series
• ILSCO ND series
• Huskie HT58 series
• Panduit CD-2001 series
• Other industry W-type dies
Installing Dies
1. Select the proper dies for the connector to be
crimped.
2. Install dies in jaws making certain that they are
properly secured by the spring-loaded, positive
lock, die buttons.
Preparing Cable
Follow the lug manufacturer’s instructions for appropri-
ate cable strip length.
Crimping Direction
(evenly spaced)
First Compression
Crimping Direction
SIDE A
(evenly spaced)
Crimping Direction
SIDE B
(evenly spaced)
First Compression
SIDE A
First Compression
SIDE B
Crimping Procedure
1. Insert conductor into the connector and align the
tool and die on the connector. Start in the center for
splices and “H” frames; and on the end, nearest the
pad, for terminals.
2. Activate the tool by pulling the trigger. Continue to
hold the trigger until the ram retracts. This is the
signal that the crimp is complete.
3. Continue crimping the connector until the correct
number of crimps has been completed. Work from
the center to the outer edges for splices and “H”
frame connectors, alternating sides if possible, for
the best compression connections.
An incomplete crimp can cause a fire.
• Use proper die, connector, and cable combinations.
Improper combinations can result in an incomplete
crimp.
• The relief valve sounds and the ram automatically
retracts to indicate a completed crimp. If you do not
hear the sound of the relieve valve or the ram does
not automatically retract, the crimp is not complete.
Failure to observe these warnings could result in
severe injury or death.
