Textron 642211, Setup, Parts & Maintenance

Page: 19 / 56

2180
Estate
Series
17
Note: Always use Bunton replacement belts, not general purpose belts. Bunton belts are
specially designed for use on commercial mowers and will normally last longer.
ENGINE-CUTTERDECK (PTO) BELT
1. Set the cutterdeck in the lowest height-of-cut
position.
2. Attach a short extension to a 3/8" drive ratchet.
Insert the ratchet extension into the square hole
in the idler arm and use the ratchet to rotate the
idler assembly enough to remove the belt.
Remove the belt from the idlers and center
cutterdeck pulley. Push belt back under engine
deck.
3. Disconnect the electric clutch from the wire
harness at plug
P .
4. Remove the carriage bolts securing torque
restraint
Q to clutch R . Remove torque restraint.
5. Remove old belt from the machine.
6. Install a new belt by performing the these steps in
reverse order.
BELT REPLACEMENT