Textron Specialized Vehicles Cushman Shuttle 4 ELiTE 2020, Owner'S Manual

Page: 43 / 64

M
AINTENANCE
41
Wheel Installation
NOTICE: To decrease the risk of component damage, do not tighten the lug nuts
to more than the specified torque.
Always install lug nuts using a cross sequence pattern to ensure the
even seating of the wheel against the hub.
1. Install the wheel on the hub with lug nuts. Make sure the valve stem is to the out -
side.
2. Finger tighten the lug nuts.
3. Using the cross tightening pattern shown to the right, tighten the lug nuts to
65 - 85
ft.lbs. (88 - 115 Nm)
. Tighten in increments of 20 ft. lbs. (27 Nm).
LIGHTS
• Clean the lights frequently to maximize visibility.
• Replace burned out bulbs promptly.
Do not operate this vehicle at night or in low light if any bulbs are burned out. Poor light -
ing reduces visibility that could cause an accident resulting in severe injury or death.
NOTICE: Replacement bulbs are available from a local Distributor, an authorized Branch or the Service Parts
Department.
LED Headlight Assembly Replacement
1. Disconnect the headlight harness from the headlight.
2. Remove the screws securing the headlight assembly to
the headlight bezel.
3. Remove the headlight assembly and install the new
one with screws.
4. Connect the harness to the headlight assembly.
Brake Light
Remove the two phillips head screws securing lens
and pull lens out of housing to access the brake light
bulb. Remove the light bulb and install a new bulb,
making sure bulb makes good contact with socket.
Replace the lens and reinstall the phillips head
screws.
Lug Nut Torque 65 - 85 ft.lbs. (88 - 115 Nm)
Lug Nut Tightening Pattern
Screw
Headlight Housing
or
LED Headlight
Assembly
Rear Fender
Lens
Bulb