TEXIO LSG SERIES, Instruction Manual

Page: 109 / 167

97
3-6. BATT Test Automation
Background The BATT test function creates an automatic test
to test the discharge of Battery products.
The test will discharge in a fixed mode (CC, CR,
CP) and will end after a defined stop point (stop
voltage, stop time, stop AH) has been detected.
The information about discharge test (discharge
time, battery AH, battery WH) can be finally seen
on the panel.
The LSG also has a user-defined cutoff setting in
the event that the Battery test fails.
The diagram below shows an example of the BATT
Test Automation function:
Example The test will run in the specified mode with defined
values and will stop when the defined stop values
are reached.
Vin
Current
t
SlewRate =
0
Setting
CC mode
SlewRate ?
Stop Time
Begin Discharge
Stop AH
Stop Volt
AH