66
and that the wheels stay inside the lawn at all time. If the robot hits/touches an
obstacle, the boundary wire must be moved further away from the edge and the test
must be carried out again. If there are several centimeters of safety distance to the
nearest obstacle / soil bed, then the boundary wire can be moved closer to the edge.
Repeat the test and see if OK. However, it is recommended to have at least 1 cm
safety distance all around the edge.
9. At the charging station, the robot will start charging the battery completely. Should it
happen that the robot cannot go into charging station, the position of the charging
station (or the boundary wire in front of it) will probably need to be adjusted. Also check
that the surface is flat and solid.
NOTE: The robot will automatically switch off if it does not receive any input within
30 seconds after being turned on.
10. Setting
TIP
Setting the year, date and time can also be done by connecting
the robot to the
App
rather than doing via the display of the robot.
When connecting to the App, the time and
date are set automatically.
See section 16 "Setting Up App".
Start by setting the year, date, and time, as it is the basis of
programming
The setting starts with year, date, and finally time. To enable setting the year, date and
time keep pressing for 5 sec until the icon and a number is blinking on the display.
Use or to select the year you want. The press to confirm each number until the
year is set correctly. Same method are used for date and time.
Note, that the date setting always starts with month indication and then month day. In the
image examples below is the date therefore August 25 (08.25). When the year, date and
time settings are saved, the display will show .
11. PIN code setting
To change the PIN code, keep pressing and down at the same time for 3 seconds,
after which the icon will blink and "PIN 1" will appear on the display. now the old PIN
code must be entered, this is done by using or and to confirm each individual
number until the old PIN is fully entered. Then "PIN 2" will appear on the display and the
new PIN code can be entered in the same way as the old PIN code (in the image example
below, new PIN code is set to 1234).
Once the new PIN is entered, the display will show and the new PIN code is saved.
