Texas HP 140, Manual

Page: 21 / 36

Warning: Do not adjust the nozzle while the spray gun is active and the water is running
Turbo lance
The Turbo lance sends out a consistent thin razor-sharp steam of water, which is ideal for
removing tough dirt and filth. Note, the turbo lance cannot be adjusted and that the razor-sharp jet
can damage fragile surface such as paint on a car or rubber strips
Soap settings
High water pressure gives a low soap concentrated solution. Low pressure gives a high soap
concentrated solution.
Soap dispenser on HP 170
On the HP 170 soap dispenser you can adjust and switch between the soap containers
Tip: If you want to soap the work area do as follows:
1. Turn off the power supply
2. Turn the water pressure down fully
3. Turn on the water
4. Activate the gun and spray (Important: The machine must not
produce any pressure)
Important: The soap must be mixed with water
Warning: Corrosive soap or detergent and a too concentrated solution can damage the surface
you are working on, which are not covered by the warranty.
Recommended working procedure

Dissolve dirt by applying detergent to the working surface.

Let the detergent act for 1 to 2 minutes, but do not let it dry.

On vertical surfaces, swab from the top and downwards.

Avoid rinsing water to run on cleaned surfaces
Storage

Turn off the machine.

Turn off the water supply.

Drain the soap container for detergent.

Discharge remaining pressure by holding the trigger until no more water comes out of the
nozzle.

Engage the spray gun safety lock.

Remove the plug from the socket.