12
92/95 Octane
SAE 30 Oil
Assembly of lower handle:
Fit the two lower handle tubes on the
chassis first. Pull the long steel bolt
out of the chassis and gear, see
arrow. Then push the two tubes
through the holes and replace the
long bolt. REMEMBER to tighten the
bolt.
Assembly of upper handle:
Now fit the upper handle using the
plastic adjusting screws. Note that
these are marked with a pivot point,
which must face each other (as
shown by the arrows) for the handle
to function correctly.
Gear cable and throttle cable:
The gear cable and lever are fitted
on the right side of the handle, and
the throttle cable on the left side.
Note – Oil and petrol are not included !
Oil and petrol
Oil and petrol are not included with
the machine. Fill the motor with 0.6
litres of SAE 30 motor oil and octane
92 or 95 unleaded petrol.
For further information about the
motor, see the attached motor
manual.
