www.ti.com
Appendix B
15
SNAU228 – January 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
USB2ANY Cable Connections
Table 2. 10-pin Cable Pinouts (continued)
Schematic Pin Number
Cable Pin Number
Signals Available
J4-2
9
GPIO1, I2C:SCL, OW3
J4-1
10
GPIO0, I2C:SDA, OW4
NOTE:
The pin numbers for J4 on the schematics are for reference only and do not correspond to
the pin numbers for cable connections.
The 30-pin cable is also about 6 inches in length and has a keyed female 30-pin IDC connector on each
end. This cable provides access to all available signals. The cable should be connected to the USB2ANY
board as
Figure 15
shows (note that the key must be facing up, away from the board).
Figure 15. 30-Pin IDC Cable Connector
Connect the opposite end of the cable to the EVM or other target device. The red stripe on the cable
indicates pin 1.
Figure 16. 30-Pin IDC Cable Detail
Table 3. 30-pin Cable Pinouts
Schematic Pin Number
Cable Pin Number
Signals Available
J3-8
1
DAC0
J3-7
2
PIO12, CLOCK, EFC0, INT3
J3-6
3
+5VEXT