Appendix A Summary of Using Code Composer Studio v3.3
this appendix describes basic steps on how to use Code Composer Studio v3.3, or CCS, to compile
firmware for UCD3138. A design flow is described while detailed steps for firmware code creation, and
firmware debugging along with hardware are obviously beyond the scope of this user’s guide and this
appendix.
A.1
Setup Code Composer Studio v3.3 for UCD3138
The recommended version of Code Composer Studio is v3.3. After completing the CCS v3.3 installation,
and when first time open CCS, a window as shown in Figure A1 will be prompted to allow users to select
their required configuration. For UCD3138 device, please select “ARM7 SIMULATOR BIG ENDIAN”. Click
“ADD” and then “Save & Quit”.
Figure 24. Setup Code Composer Studio v3.3 for the UCD3138
If CCS has existing configurations in “My System”, click “Launch Setup” under “File” pull-down menu.
Select “Remove All” to remove the existing configurations; then select “ARM7 SIMULATOR BIG ENDIAN”
as shown in
, Click “ADD” and then “Save & Quit” for UCD3138 device.
26
Summary of Using Code Composer Studio v3.3
SLUUA80 – January 2013
Copyright © 2013, Texas Instruments Incorporated