Texas Instruments TUSB1002EVM, User Manual, Page: 2 / 16

USB 3.1
Type-
W
Cable
USB 3.1
Type-
W
Cable
USB 3.1 Type-B Receptacle
USB 3.1 Device/Sink (External Hard Drive, Thumb Drive, and so forth)
USB 3.1 Type-B Receptacle (Input)
USB 3.1 Type-A Receptacle (Output)
TUSB1002 EVM
USB 3.1 Host/Source (Desktop, Laptop, Docking Station, and so forth)
USB 3.1 Type-A Receptacle
Copyright © 2016, Texas Instruments Incorporated
Introduction
www.ti.com
2 SLLU245 – May 2016
Submit Documentation Feedback
Copyright © 2016, Texas Instruments Incorporated
TUSB1002 Evaluation Module
1 Introduction
The TUSB1002 is a dual-channel, USB 3.1 SuperSpeed Plus re-driver and signal conditioner supporting
data rates of 10.0 Gbps. The device complies with USB 3.1 specification revision 1.0, supporting electrical
idle condition and low-frequency periodic signals (LFPS) for USB 3.1 power management modes.
The device offers programmable equalization that extends the interconnect distance between two devices.
Also, the device supports low-power modes when unplugged. The device can also function in USB-
compliance mode to test the transmitter for compliance to voltage and timing specifications per USB 3.1
compliance specification.
This EVM is designed to be used as a medium connection between a USB host and a USB device. The
interface to the EVM consists of a USB 3.1 Type-A Receptacle and a USB 3.1 Type-B Receptacle.
Therefore, in order to connect the EVM to your system set up, you will most likely need 2 USB 3.1
Standard Type-A
→ B cables. Your test setup should look similar to the figure below:
Figure 1. TUSB1002 Functional System Level Block Diagram