Texas Instruments TSW14J57EVM, User Manual

Page: 6 / 20

Hardware Configuration
www.ti.com
6 SLWU092 – April 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
TSW14J57 JESD204B High-Speed Data Capture and Pattern Generator
Card User's Guide
NOTE: The typical power supply range for the TSW14J57EVM is between 10V to 14V with a power
consumption of about 14.5W. It is recommended that at least a 2 A rated supply be provided
to the TSW14J57EVM due to the current consumption increase when data is being captured
by HSDC Pro.
3.2 Switches, Jumpers, and LEDs
3.2.1 Switches and Pushbuttons
The TSW14J57 contains several switches and pushbuttons that enable certain functions on the board.
The description of the switches can be found in
Table 1 .
Table 1. Switch Description of the TSW14J57 Device
Component Description
SW1 Spare dip switches that are connected to spare FPGA inputs
SW2 Spare pushbutton that are connected to spare FPGA inputs
SW3 Board main power switch
SW4 (CPU RESET) FPGA hardware reset
SW5 Power monitor U13 reset
SW6 (UCD Reset) Power monitor U13 reset
SW7 Dip switch to set VAR adjustable step-down output voltage. Default is 1.8V
(switches 1,3,4 off, 2 on)
3.2.2 Jumpers
The TSW14J57 contains several jumpers (JP) and solder jumpers (SJP) that enable certain functions on
the board. The description of the jumpers can be found in
Table 2 .
Table 2. Jumper Description of the TSW14J57 Device
Component Description Default
SJP1 - SJP3 Sets programming mode for FPGA 2 to 3
SJP4 Power enable to general purpose 100MHz OSC Y3 1 to 2
JP1, JP2, JP4 Programming mode for USB controller U8A 1 to 2
JP5 Sets VCCIO for Arria
®
10 2 to 3