Texas Instruments TPS7B4255EVM-062, User Manual, Page: 3 / 20

1 Introduction
The Texas Instruments' TPS7B4255EVM-062 evaluation module (EVM) helps designers evaluate the operation
and performance of the TPS7B4255-Q1 LDO voltage regulator. As shown in
Table 1-1 , the TPS7B4255EVM-062
contains one TPS7B4255-Q1 LDO voltage regulator in the SCT-595 package. An optional load transient circuit
is also included to assist the user with high-speed load transient testing. To simplify current measurements, an
input current loop is included.
Table 1-1. Device Information
EVM ORDERABLE NUMBER V
OUT
PART NAME PACKAGE
TPS7B4255EVM-062 Adjustable - tracking TPS7B4255QDYBRQ1 5-pin SCT-595
1.1 Before You Begin
This evaluation module is not encapsulated and has exposed terminals with voltages that are connected to the
main power supply. The following warnings are noted for the safety of anyone using or working close to the
TPS7B4255EVM-062. Observe all safety precautions.
WARNING
Failure to adhere to these steps or to not heed the safety requirements at each step may lead to
shock, injury, and damage to the hardware. Texas Instruments is not responsible or liable in any way
for shock, injury, or damage caused by negligence or failure to heed advice. If you are not trained
in the proper safety of handling and testing power electronics please do not test this evaluation
module.
CAUTION:
!
Caution! Do not leave EVM powered when unattended.
HOT SURFACE:
Caution Hot Surface! Contact may cause burns. Do not touch. Please take the proper
precautions when operating.
www.ti.com Introduction
SLVUCA5 – JUNE 2022
Submit Document Feedback
TPS7B4255EVM-062 Evaluation Module 3
Copyright © 2022 Texas Instruments Incorporated