Texas Instruments TPS65295, User Manual, Page: 4 / 20

Test Setup and Results
www.ti.com
4 SLUUC02 – February 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
TPS65295EVM-079, 4.5-V to 18-V
IN
, complete DDR4 power solution
evaluation module
3.2 Input/Output Connections
The TPS65295EVM-079 is provided with input/output connectors and test points as shown in Table 4 and
Jumpers description shown in Table 3 . A power supply capable of supplying greater than 8A must be
connected to J1 through a pair of 20-AWG wires or better. The load must be connected to J2 through a
pair of 20-AWG wires or better. The maximum load current capability is 8 A. Wire lengths must be
minimized to reduce losses in the wires.
Table 3. Jumpers
# FUNCTIONS COMMENT
J1 Connects the PVIN_VPP and
VCC_5V Need to jump if share the same
power for PVIN_VPP and
VCC_5V
J6 Connects the VLDOIN and VDDQ Need to jump when no external
VLDOIN exists on J8
J8 External VLDOIN 1.2V Input for
VTT power input It is for test, leave NA if not use
J10 VPP and VDDQ buck enable SLP_S4# pin
J11 VTT enable VTT_CNTL pin
Buck converter outputs are white and have a label for each location. Close to any of these test points
there are black ground test points to allow for DVM measurement or to use a metal exposed scope probe
to reduce common mode noise measurements. All test points are described in the following
Table 4 .
Table 4. Connection and Test Points
TP# NAME SIGNAL COLOR
TP1 VIN_5V VCC_5V input or test point for PVIN_VPP White
TP2 VIN_5V VCC_5V input or test point for PVIN_VPP Silver
TP3 VPP Output voltage for VPP White
TP4 VPP Output voltage for VPP Silver
TP5 GND GND Black
TP6 GND GND Black
TP7 PVIN VDDQ Buck power input test point White
TP8 VDDQ Output voltage for VDDQ White
TP9 PVIN VDDQ Buck power input test point Silver
TP10 VDDQ Output voltage for VDDQ Silver
TP11 GND GND Black
TP12 GND GND Silver
TP13 GND GND Black
TP14 GND GND Silver
TP15 VTT Output voltage for VTT White
TP16 VLDOIN VLDOIN input or test point White
TP17 GND GND Black
TP18 GND GND Black
TP19 VTTREF Output voltage for VTTREF White
TP20 GND GND Black
TP21 GND GND Black
TP22 PGOOD Power good signal White
TP23 SLP_S4# VPP and VDDQ buck enable White
TP24 VTT_CNTL VTT enable White