Texas Instruments TPS650830EVM-095, User Manual, Page: 12 / 26

Setup
www.ti.com
Once installed, the GUI appears as seen in Figure 10 .
It is possible that first running the GUI and therefore the USB2GUI box, that the user will have to update
the USB2ANY box’s firmware. If this is the case, the user will receive a message similar to
Figure 9 .
Figure 9. Firmware Update Required Message
5.3 Running the Software
Click on the TPS65083xEVM icon to start the software. If no icon appears on the host computer, then use
the start button in the lower left corner of the screen to browse the program folders to find the software.
The default directory for software installation is Program Files\Texas Instruments\TPS65083xEVM.
Figure 10 is a diagram of the GUI and beneath the figure are descriptions of each feature that the GUI has
to offer. The GUI has register and bit names. The register name is listed to the left of the data and I2C
addresses. To see the bit names, hover the mouse over the data bit and the bit name will appear for as
long as the mouse is positioned over the bit. See the TPS65083x data sheet for detailed description on
these registers.
Figure 10. Software Overview
12 TPS650830EVM-095 SLVUAD6 – December 2014
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated