Setup
•
(A) = USB2ANY Detection – If this message reads “USB2ANY Detected”, then the GUI and USB2ANY
are operating correctly in that they are communicating to one another.
–
If this message reads “USB2ANY Not Detected” then the GUI and USB2ANY are not operating
correctly and communication needs to be established. Try unplugging the USB cable, shutting
down and restarting the GUI, followed by plugging in the USB cable.
•
(B) = I2C Address Selection – Select the desired I2C address before attempting to communicate. The
TPS65083x operates on 1 of 3 addresses: x30, x32, or x34, depending on the hardware configuration
of SLAVEADDR pin.
•
(C) = Read and Write All Commands – Use read and write all commands to read or write data on all
the registers featured in the REGISTER List.
•
(D) = File – User can select to save or load registers to or from a .txt file.
•
(E) = I2C Activity – Logs all user activity over the I2C communication bus since opening the GUI or
since last “Clear”. User can clear activity log by clicking on the “Clear” button.
•
(F) = Auto Read – User can select to read all registers or just a single register every 1, 5, 10, or 20
seconds, as desired.
13
SLVUAD6 – December 2014
TPS650830EVM-095
Copyright © 2014, Texas Instruments Incorporated
