2 Setup
This section describes how to properly use the TPS628436-7-8EVM-167.
2.1 Input/Output Connector Descriptions
Table 2-1. Input/Output Connectors
Input/Output
Description
Jx1, Pin 1 and 2 – VIN
Positive input connection from the input supply for the EVM.
Jx1, Pin 3 and 4 – S+/S-
Input voltage sense connections. Measure the input voltage at this point.
Jx1, Pin 5 and 6 – GND
Input return connection from the input supply for the EVM.
Jx2, Pin 1 and 2 – VOUT
Output voltage connection.
Jx2, Pin 3 and 4 – S+/S-
Output voltage sense connections. Measure the output voltage at this point.
Jx2, Pin 5 and 6 – GND
Output return connection.
JPx1 – EN
EN pin input jumper. Place the supplied jumper across ON and EN to turn on the IC. Place the jumper
across OFF and EN to turn off the IC.
Note
To achieve a different output voltage, disconnect the power supply of the EVM. Replace the
R11/R21/R31 accordingly (refer to Sec. 6.1 of the data sheet), then power up the device again.
2.2 Setup
To operate the EVM, set jumpers JPx1 to the desired position per
. Connect the input supply to Jx1
and connect the load to Jx2.
Setup
4
TPS628436-7-8EVM-167 Evaluation Module
Copyright © 2021 Texas Instruments Incorporated
