10.10 Monitor
When the
Monitor
screen (
) is selected, the screen changes to display real-time data of the
parameters that are measured by the device. This screen provides access to:
• Graphs of
Vout
,
Iout
,
Vin
,
Pout
, and
Temperature
•
Start and Stop Polling
which turns ON or OFF the realtime display of data
• Quick access to
On/Off Config
• Control pin activation and
OPERATION
command
• Margin control
• Clear Fault: Selecting
Clear Faults
clears any prior fault flags.
With two devices stacked together, the
Iout
reading is the total load supported by both devices. There is also an
Iout
, which shows the current in each phase.
Figure 10-10. Monitor Screen
Using the Fusion GUI
40
TPS546B24A 2-Phase SWIFT™ Step-Down Converter Evaluation Module
User's Guide
SLUUC48A – FEBRUARY 2020 – REVISED FEBRUARY 2022
Copyright © 2022 Texas Instruments Incorporated