5.2 Recommended Test Setup
Figure 5-2. TPS53515EVM-587 Top Layer for Test Setup
Input Connections:
1. Prior to connecting the DC input-source, VIN, TI recommends to limit the source current from VIN to 10 A
maximum. Ensure that VIN is initially set to 0 V and connected as shown in
.
2. Connect the voltmeter V1 at TP1 (VIN) and TP4 (GND) to measure the input voltage.
Output Connections:
1. Connect the load to J3 and set the load to constant-resistance-mode to sink 0 ADC before VIN is applied.
2. Connect the voltmeter V2 at TP7 (VOUT) and TP9 (GND) to measure the output voltage.
Test Setup
SLUUAS1C – OCTOBER 2013 – REVISED NOVEMBER 2021
TPS53515 Step-Down Converter Evaluation Module User's Guide
5
Copyright © 2021 Texas Instruments Incorporated
