Texas Instruments TPS26600-02EVM, User Manual, Page: 4 / 24

General Configurations
www.ti.com
4 SLVUAV3A – August 2016 – Revised February 2017
Submit Documentation Feedback
Copyright © 2016–2017, Texas Instruments Incorporated
TPS26600-02EVM: Evaluation Module for TPS2660x
4 General Configurations
4.1 Physical Access
Table 2 lists the TPS26600-02EVM input and output connector functionality, Table 3 describes the test
point availability, and Table 4 describes the jumper functionality.
Table 2. Input and Output Connector Functionality
Connector Label Description
T1 CH1 VIN1(+), GND(–) CH1 input power supply to the EVM
T2 VOUT1(+), GND(–) CH1 output from the EVM
T3 CH2 VIN2(+), GND(–) CH2 input power supply to the EVM
T4 VOUT2(+), GND(–) CH2 output from the EVM
Table 3. Test Points Description
Channel Test Points Label Description
CH1 TP1 FLTb1 CH1 fault indicator
TP2 VIN1 CH1 power supply input
TP3 VOUT1 CH1 output voltage
TP4 SHDNb1 CH1 shutdown input
TP5 IMON1 CH1 output current monitor
TP7, TP8, TP9 GND GND
CH2 TP10 FLTb2 CH2 fault indicator
TP11 VIN2 CH2 power supply input
TP12 VOUT2 CH2 output voltage
TP13 SHDNb2 CH2 shutdown input
TP14 IMON2 CH2 output current monitor
TP16, TP17, TP18 GND GND
Table 4. Jumper and LED Descriptions
Jumper Label Description
J1 J1 CH1 fault LED pulled to VIN1, if installed
J2 J2 CH1 output power indicator LED pulled to VOUT1, if installed
J3 J3 CH1 bulk output capacitor connects to VOUT1, if installed
J4 MODE CH1 MODE selection
spac 1-2 position sets latch-off mode
spac 2-3 position sets auto-retry mode
spac Open position sets circuit breaker with auto-retry mode
J5 ILIM CH1 current limit setting
spac 1-2 position sets 2.23 A
spac 3-4 position sets 1.5 A
spac 5-6 position sets 1 A
spac 7-8 position sets 0.2 A
J6 UVLO CH1 UVLO setting
spac Sets internal UVLO (15 V), if installed
J7 OVP CH1 OVP setting
spac Sets internal OVP (33 V), if installed
J8 J8 CH2 fault LED pulled to VIN2, if installed
J9 J9 CH2 output power indicator LED pulled to VOUT2, if installed
J10 J10 CH2 bulk output capacitor connects to VOUT1, if installed