General Configurations
11
SLVUAV3A – August 2016 – Revised February 2017
Copyright © 2016–2017, Texas Instruments Incorporated
TPS26600-02EVM: Evaluation Module for TPS2660x
Figure 6. Restart From Latch-Off Mode
15. Disable the power supply.
16. Set the current limit response mode to circuit breaker with auto-retry by uninstalling the J4/J11 jumper.
17. Set the load resistance to 6
Ω
±1
Ω
and enable the load.
18. Enable the power supply and verify the circuit breaker with auto retry fault response waveform as
shown in
Figure 7. J5/J12 = Floating, Current Limit (2.23 A), Circuit Breaker With Auto-Retry Mode