Clicking the
SET ALL PORTS TO STANDARD
button sets all port to standard configurations (configuring ports in
Semi-Auto mode, enabling OSS, power policing, and DC disconnect). Clicking the
SET ALL PORTS TO AUTO
MODE
button enables
Auto Mode
for all ports.
The status of each port is shown on the configuration and telemetry page. The configuration of the ports can also
be edited on this page by clicking the RJ45 connector.
If the port is configured in
Auto Mode
, the port will turn on automatically by the PSE device after connecting a
valid PD. If not configured in
Auto Mode
, a port enable command is required. The port can be turned on only
when the PD has valid detection and classification results.
Figure 4-4. Device Configuration and Port Telemetry Page
The GUI also provides access to every register of the device in the register map.
TPS23882B1 GUI Setup
12
TPS23882B1EVM: PoE, PSE, TPS23882B1
Evaluation Module
SLVUC36 – APRIL 2021
Copyright © 2021 Texas Instruments Incorporated