Texas Instruments TPS22968-Q1, User Manual, Page: 7 / 19

www.ti.com
Setup
5.13 List of Test Points
Table 1. Test Points Functions
Test Points Name Description
J1 VIN1 DC Input to VIN1
J2 VIN2 DC Input to VIN2
J3 VOUT1 DC Output from VOUT1
J4 VOUT2 DC Output from VOUT2
JP1 VBIAS Connects VBIAS to VIN1 or VIN2
JP2 C2 Connects C2 from VIN2 to GND
JP3 C1 Connects C1 from VIN1 to GND
JP4, JP5, JP6, JP7 VOUT1 // VOUT2 Shorts VOUT1 and VOUT2 together used in parallel switch configuration
TP1 VIN1 VIN1 Connection
TP2 VIN2 VIN2 Connection
TP3 VIN1 SEN Sense connection to VIN1
TP4 VIN2 SEN Sense connection to VIN2
TP5 VOUT1 VOUT1 Connection
TP6 VOUT2 VOUT2 Connection
TP7 VOUT1 SEN Sense connection to VOUT1
TP8 VOUT2 SEN Sense connection to VOUT2
TP9 ON1 ON1 Connection
TP10 VBIAS VBIAS Connection
TP11 ON2 ON2 Connection
TP12 VOUT1 // VOUT2 VOUT1 VOUT2 connected in parallel configuration
TP13 GND Ground Connection
TP14 GND Ground Connection
TP15 GND Ground Connection
TP16 GND Ground Connection
TP17 GND Ground Connection
5.14 Test Procedure
Figure 4 shows a typical setup for the R
ON
test of the EVM. VBIAS voltage must be present for the device
to function, keep this voltage level constant between 2.5 V – 5.25 V. Adding a shunt across JP1 will
connect the VBIAS pin to VIN1 (pin1 to pin2) or VIN2 (pin2 to pin3). When testing with input voltages
below 2.5 V JP2 shunt must be removed and VBIAS tied to another voltage source.
7 SLVUAE2A – January 2015 – Revised November 2015 TPS22968/68N-Q1 Dual Channel, 5.5-V, 4-A, 27-m Ω Load Switch Evaluation
Module
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated