Texas Instruments TPS1H000-Q1 EVM, User Manual

Page: 4 / 14

Connections Descriptions
www.ti.com
4 SLVUB86 – August 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
TPS1H000-Q1 Evaluation Module (EVM)
3 Connections Descriptions
3.1 Connectors and Test Points
Table 1 lists the connector and test point descriptions.
Table 1. Connector and Test Point Descriptions
Connectors and Test Points Description
GND1 / GND2 Board GND connector, the return connection to the input power supply
IN Board input connector, 3.3- or 5-V control signal connection pin
OUT Board output pin connector, the source terminal of DMOS
FAULT Board fault output connector
CL Board current limit output connector
DIAG_EN Board Diag_En input connector, 3.3- or 5-V control signal connection pin
Vsupply Board positive input supply voltage connector
OUT1 IC output pin test point
VS IC positive input supply voltage test point
DELAY_IC IC current limit function configuration; internal pullup
3.2 Jumpers
Table 2 lists the EVM jumper descriptions.
Table 2. Jumper Descriptions
Jumpers Description
J1 Connects board IN to IN_IC.
J2 Connects VS to IN_IC.
J3 Connects a 1-µF capacitance to the GND pin of the device
J4 Connects the DIAG_EN pin to VS
J5 Connects board DIAG_EN to DIAG_EN_IC
J6 Connects the DELAY_IC pin to GND
J7 Connects a 5-V pullup resistance to DELAY_IC
J8 This jumper is used to connect the CL pin to the potentiometer R5
J9 This jumper adds a pullup resistance to the DELAY_IC pin
J10 Connects IN to +5 V
J11 This jumper is used to set a pull up for the FAULT signal
J12 Connects the input supply to the +5-V LDO
J13 This jumper is used to connect OUT to a 10-k Ω pullup resistance
J14 This jumper is used to connect OUT to OUT1 (IC OUT)
J15 This jumper connects DIAG_EN to +5 V