Texas Instruments TPA3244, User Manual, Page: 5 / 28

R
BTL
V
out
+
L
BTL
V
out
-
C
g
C
g
L
BTL
V
out
+
_
www.ti.com
Hardware Overview
5 SLVUAT5 – November 2016
Submit Documentation Feedback
Copyright © 2016, Texas Instruments Incorporated
TPA3244 Evaluation Module
1.4 TPA3244EVM Clip Overtemperature and Fault Indicators
The TPA3244EVM is equipped with LED indicators that illuminate when the FAULT or CLIP_OTW pin
goes low. See
Table 2 and the TPA3244 data sheet ( SLASEC6 ) for more details.
Table 2. Fault and Clip Overtemperature Status
FAULT CLIP_OTW Description
0 0
Overtemperature (OTE) or overload (OLP) or undervoltage (UVP). Junction temperature higher
than 125°C (overtemperature warning).
0 0
Overload (OLP) or undervoltage (UVP). Junction temperature higher than 125°C (overtemperature
warning).
0 1 Overload (OLP) or undervoltage (UVP). Junction temperature lower than 125°C.
1 0 Junction temperature higher than 125°C (overtemperature warning)
1 1 Junction temperature lower than 125°C and no OLP or UVP faults (normal operation)
1.5 TPA3244EVM LC Filter
The TPA3244EVM is equipped 10-µH inductors and 1-µF capacitors for the output LC filter. These
components are setup as a Type-2 filter shown in
Figure 2 , since this allows the support of both BTL and
SE output configurations required for the EVM.
Figure 2. Type-2 Filter for BD or AD Modulation