Texas Instruments TPA3156D2EVM, User Manual, Page: 5 / 17

www.ti.com
Operation
5 SLOU499 – October 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
TPA3156D2EVM User’s Guide
Table 4 lists the settings for a single-ended input with auto recovery, PLIMIT, and BTL (single-channel
output).
Table 4. TPA3156D2EVM Setting 1 (Single-Channel Output)
Setting Description
J6 (RIN) No audio input
J9 (LIN) L channel audio input
JP1 (GNDR+) and JP3 (GNDR–) set to IN R channel off
JP4 (GNDL+) and JP6 (GNDL–) set to OUT L channel on
JP5 (LGND) set to IN Single-ended input (L channel)
JP7 set to IN Set PLIMIT
R4 Change PLMIT voltage value
JP8 (/SD=/FAULT) set to IN Auto-recovery mode
J11 (MODESEL=L) Low idle-loss mode
Table 5 lists the settings for a single-ended input with auto recovery, PLIMIT, and PBTL (mono output).
Table 5. TPA3156D2EVM Setting 2 (Mono Output)
Setting Description
J6 (RIN) R channel audio input
J9 (LIN) No audio input
JP1 (GNDR+) and JP3 (GNDR–),set to OUT R channel on
JP4 (GNDL+) and JP6 (GNDL–), set to IN L channel off, PBTL mode
JP2, set to IN Single-ended input (R channel)
JP7, set to IN Set PLIMIT
R4 Change PLMIT voltage value
JP8 (/SD=/FAULT) set to IN Auto-recovery mode
J11 (MODESEL=L) Low idle-loss mode
2.8 Separate PVCC and AVCC Supply Support
Supplying a voltage of AVCC that is lower than PVCC (for example PVCC = 24 V and AVCC = 12 V),
reduces the power dissipation on the internal LDO. This gives customers the flexibility to choose between
the extreme, low-idle current mode (J3: 1 and 2 set to IN, with separate AVCC) and single power supply
mode (J3: 2 and 3 set to IN, without AVCC).