Texas Instruments TMS570LS12x, User Manual

Page: 7 / 27

www.ti.com
HDK Specifications
1.5 HDK Specifications
• Board supply voltage: 5 V–12 V Vdc
• Board supply current: 130 mA typ (fully active, CPU at 180 MHz)
• Dimensions: 4.90” x 4.30” x 0.85” (LxWxH)
1.6 Basic Operation
The HDK is designed to work with TI’s Code Composer Studio and other third party ARM IDEs. The IDE
communicates with the board through the embedded emulator or an external JTAG emulator. To start,
follow the instructions in the Quick Start Guide to install Hercules-specific software. This process will install
all of the necessary development tools, documentation and drivers.
1.7 Memory Map
The TMS570LS12 family of MCUs have a large byte addressable address space. Table 1-1 shows the
address space of a TMS570LS1227 microcontroller on the left with specific details of how each region is
used by the HDK on the right. By default, the internal memory sits at the beginning of the address space.
The SDRAM is mapped into CS0 space on the EMIF. CS[4:2] are used for synchronous memory for
example SRAM, NOR Flash, NAND Flash, and so forth.
Table 1-1. TMS570LS12 Memory Map
Start Address End Address HDK
0x0000 0000 0x002F FFFF Flash
0x0800 0000 0x0803 FFFF RAM
0x0840 0000 0x0843 FFFF RAM-ECC
0x6000 0000 0x63FF FFFF CS2 Async RAM
0x6400 0000 0x67FF FFFF CS3 Async RAM
0x6800 0000 0x7BFF FFFF CS4 Async RAM
0x8000 0000 0x87FF FFFF CS0 Sync SDRAM
1.8 Power Supply
The HDK board operates from a 12 V external power supply connected to the main power input
(P1), a 2.5 mm, barrel-type plug. Internally, the +12 V input is converted into +1.2 V, +3.3 V and +5.0 V
using Texas Instruments swift voltage regulators and PTH power module. The +1.2 V supply is used for
the MCU core while the +3.3 V supply is used for the MCU's I/O buffers and other module on the board.
The +5.0 V supply is used for ADC power (second option) and USB VBUS.
There are multiple power test points on the HDK board. The three main test point pairs provide a
convenient mechanism to check the HDK’s current for each supply.
Table 1-2 shows the voltages for each
test point and what the supply is used for.
Table 1-2. Power Test Points
Test Point Pair Voltage Voltage Use
TP14 and TP15 1.2 V MCU core
TP16 and TP17 3.3 V MCU IO and logic
TP18 and TP19 1.2 V MCU PLL
TP20 and TP21 3.3 V MCU Flash pump
TP22 and TP23 3.3 V or 5.0 V MCU MibADC, and ADREFHI
(J8 to enable 5 V)
7 SPNU568 – September 2012 Introduction
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated