Texas Instruments TMS320C54x, User Manual

Page: 329 / 469

Building a Table for an On-Chip Boot Loader
10-29 Hex Conversion Utility Description
10.9.3 How to Build the Boot Table
Table 10–2 summarizes the hex conversion utility options available for the
boot loader.
Table 10–2. Boot-Loader Options
(a) Options for all ’C54x devices
Option Description
–boot Convert all sections into bootable form (use instead of a
SECTIONS directive)
–bootorg PARALLEL Specify the source of the boot loader table as the parallel
port
–bootorg SERIAL Specify the source of the boot loader table as the serial port
–bootorg value Specify the source address of the boot loader table
–bootpage value Specify the target page number of the boot loader table
–e
value
Specify the entry point for the boot loader table
(b) Options for ’C54xLP devices only
Option Description
–bootorg WARM
or –warm Specify the source of the boot loader table as the table cur-
rently in memory
–bootorg COMM Specify the source of the boot loader table as the commu-
nications port
–spc value Set the serial port control register value
–spce
value
Set the serial port control extension register value
–arr value Set the ABU receive address register value
–bkr value Set the ABU transmit buffer size register value
–tcsr value Set the TDM serial port channel select register value
–trta value Set the TDM serial port receive/transmit address register
value
–swwsr value Set the software wait state register value for PARALLEL/
WARM boot mode
–bscr value Set the bank-switch control register value for PARALLEL/
WARM boot mode