TMP007EVM Software
shows the typical response when the SM-USB-DIG is plugged into the USB port of a computer
for the first time. Typically, the computer responds with a
Found New Hardware, USB Device
pop-up
dialog. The pop-up window then changes to
Found New Hardware, USB Human Interface Device
. This
pop-up indicates that the device is ready to be used. The SM-USB-DIG uses the human interface device
drivers that are part of the Microsoft
®
Windows
®
operating system.
Figure 5. Typical PC Behavior After Connecting TMP007EVM
4
TMP007EVM Software
This section discusses how to install the TMP007EVM software.
4.1
Hardware Requirements
The TMP007EVM software is tested on Microsoft Windows 7 operating systems (OS) with United States
regional settings. The software should also function on other Windows OS platforms.
4.2
GUI Software Installation
The software is available through the TMP007EVM product folder on
. To install the software
to a computer, download the
SBOC441.zip
file from www.ti.com, unzip the file, and open the TMP007EVM
software folder. Locate and launch the TMP007EVM installation file (
setup.exe
), as shown in
.
This file is located in the
Installer
directory.
Figure 6. TMP007EVM Software Installation Files
6
TMP007EVM User's Guide
SBOU137A – May 2014 – Revised December 2014
Copyright © 2014, Texas Instruments Incorporated