Texas Instruments TMP007EVM, User Manual, Page: 3 / 25

www.ti.com
Introduction to the TMP007 and TMP007EVM
1.2 Related Documentation from Texas Instruments
The following documents provide information regarding Texas Instruments' integrated circuits used in the
assembly of the TMP007. This user's guide is available from the TI web site under literature number
SBOU137 . Any letter appended to the literature number corresponds to the document revision that is
current at the time of the writing of this document. Newer revisions may be available from the TI web site ,
or call the Texas Instruments' Literature Response Center at (800) 477-8924 or the Product Information
Center at (972) 644-5580. When ordering, identify the document by both title and literature number.
Table 2. Related Documentation
Document Literature Number
TMP007 product data sheet SBOS685
SM-USB-DIG platform user guide SBOU098
2 TMP007EVM Hardware Setup
Figure 2 shows the system setup for the EVM. The computer runs the graphical user interface (GUI)
software that communicates with the SM-USB-DIG over a USB connection. The SM-USB-DIG translates
USB commands from the computer into power, I
2
C, SPI™, and general-purpose input/output (GPIO)
commands for the TMP007 test board. Note that the TMP007EVM does not require any additional
components to operate.
Figure 2. TMP007EVM Hardware Setup
3 SBOU137A – May 2014 – Revised December 2014 TMP007EVM User's Guide
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated