Texas Instruments TMAG5273, User Manual

Page: 8 / 21

4.1.3.2 GUI Operation
To operate the GUI, follow these steps:
1. Connect to and launch the GUI as described in
Section 4.1.3.1 .
2. With the EVM connected to the GUI, after closing the README.md file page the text near the bottom-left
hand corner of the GUI should read Hardware Connected as in Figure 4-5 .
Figure 4-5. Hardware Connected
a. If Hardware Connected does not show in the bottom-left hand corner of the GUI, check different
hardware COM ports under Options >> Serial Port , as shown in Figure 4-6 .
Figure 4-6. Change Serial Port
b. If the hardware still does not connect, make sure you are using the correct GUI and EVM combination.
3. Click the Registers icon shown in Figure 4-7 (also available on the left side menu) to view the register map,
and change device settings, and enable automatic register read. For questions about a register or register bit
field, select the
icon. For more questions about registers, check the data sheet.
Figure 4-7. Registers Page Icon
4. To view and save graphical data from the results registers, click on the Plots icon shown in Figure 4-8 (also
available on the left side menu).
Figure 4-8. Plots Page Icon
EVM Operation www.ti.com
8 TMAG5273 Evaluation Manual SLYU058 – MAY 2021
Submit Document Feedback
Copyright © 2021 Texas Instruments Incorporated