Texas Instruments TLV841EVM, User Manual

Page: 9 / 20

3 EVM Connectors
This section describes the connectors, jumpers, and test points on the EVM as well as how to connect, set up,
and properly use the EVM. Each device has an independent supply connection, but all grounds are connected
on the board.
3.1 EVM Test Points
Table 3-1 lists the test points and functional descriptions. All TLV841 pins have a corresponding test point to the
EVM. These test points are located close to the pins for more accurate measurements.
Table 3-1. Test Points
TEST POINT
NUMBER
TEST POINT
SILKSCREEN
LABEL
FUNCTION DESCRIPTION
TP1 VDD Connection to VDD pin
Allows the user to monitor the VDD pin. The VDD pin
connects to the input power supply.
TP2 RESET Connection to RESET pin Allows the user to monitor the RESET output pin.
TP3 MR, SENSE, CT
Connect to SENSE pin (variant option #1)
Connect to MR pin (variant option #2)
Connect to CT pin (variant option #3)
Depending on which variant option is on the EVM board,
the EVM allows the user to connect to:
•
SENSE pin. The SENSE pin is the voltage that will be
monitored by TLV841S
• MR pin. The MR (Manual Reset) pin, when pulled to a
logic low allows the user to assert a reset signal on the
RESET output pin.
• CT pin. Allows the user to monitor the CT pin. The CT
capacitor sets the time delay of the RESET output.
TP4 GND Connection to GND pin. Allows the user to connect to the ground plane.
www.ti.com EVM Connectors
SNVU755A – JANUARY 2021 – REVISED JUNE 2021
Submit Document Feedback
TLV841EVM Voltage Supervisor User Guide 9
Copyright © 2021 Texas Instruments Incorporated