EVM Setup
4
SBVU057 – December 2019
Copyright © 2019, Texas Instruments Incorporated
TLV751-EVM Evaluation Module
2
EVM Setup
This section describes how to properly connect and set up the TLV751-EVM, including the jumpers and
connectors on the EVM board.
2.1
Inputs/Outputs Connectors and Jumper Descriptions
2.1.1
J1 – OUT1_S
Regulated output voltage one sense
2.1.2
J2 – IN1
Input power supply one voltage connector. Twist together the positive input lead and ground return lead
from the input power supply one, and keep them as short as possible to minimize input inductance.
2.1.3
J3 – OUT1
Regulated output voltage one connector
2.1.4
J4 – IN1_S
Input voltage one sense
2.1.5
J5 –GND
Input supply one ground return connector
2.1.6
J6 – GND
Regulated output voltage one ground return connector
2.1.7
J7 – IN2
Input power supply two voltage connector. Twist together the positive input lead and ground return lead
from the input power supply two, and keep them as short as possible to minimize input inductance.
2.1.8
J8 – OUT2
Regulated output voltage two connector
2.1.9
J9 – IN2_S
Input voltage two sense
2.1.10
J10 – GND
Input supply two ground return connector
2.1.11
J11 – EN1
Output voltage one enable. To enable output voltage one, connect a jumper to short VIN1 to EN1.
2.1.12
J12 – GND
Regulated output voltage two ground return connector
2.1.13
J13 – OUT2_S
Regulated output voltage two sense