Texas Instruments TLV62585PEVM-030, User Manual, Page: 3 / 12

www.ti.com
Setup
3 SLVUBE7 – March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
TLV62585PEVM-030 Evaluation Module
2 Setup
This section describes how to properly use the TLV62585PEVM-030.
2.1 Connector Descriptions
J1, pin 1 and pin 2 – VIN Positive input voltage connection from the input supply for the EVM
J1, pin 3 and pin 4 – S+/S– Input voltage sense connections. Measure the input voltage at this
point.
J1, pin 5 and pin 6 – GND Input return connection from the input supply for the EVM
J2, pin 1 and pin 2 – VOUT Positive output voltage connection
J2, pin 3 and pin 4 – S+/S– Output voltage sense connections. Measure the output voltage at this
point.
J2, pin 5 and pin 6 – GND Output return connection
J7 – PG/GND The PG output appears on pin 1 of this header with a convenient
ground on pin 2
JP1 – EN EN pin jumper. Place the supplied jumper across ON and EN to turn
on the IC. Place the jumper across OFF and EN to turn off the IC.
JP2 Place the supplied jumper across both pins to reference the PG
signal to VOUT
J8 Convenient ground connection
2.2 EVM Setup
To operate the EVM, set jumpers JP1 and JP2 to the desired positions per Section 2.1 . Connect the input
supply to J1, between VIN and GND and connect the load to J2 between VOUT and GND.