Texas Instruments TLC6C5716-Q1, User Manual, Page: 3 / 14

USB2ANY
TLC6C5716EVM
xx
xx
xx
xx
xxx
xx
xx
xx
xx
xx
DC Supply
5V
Vsense
Vcc
GND
USB cable
Ribbon Cable
Put Shunt on J3 8 to suppl y Vcc
f rom US B2AN Y
www.ti.com
Test Setup and Results
3 SLVUBD7 – May 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
TLC6C5716-Q1 Evaluation Module
ADVANCE INFORMATION
2 Test Setup and Results
2.1 Hardware Setup
Figure 2 shows the hardware setup of the TLC6C5716-Q1 EVM.
• Connect the 5-V power supply to the LED board between TP1 (SENSE) and TP3 (GND), use the 5-V
micro-USB supply connected to J36 to supply the LED.
• Put a shunt on J53 to connect the USB2ANY 3.3-V supply to VCC. In this case, extra DC supply is not
needed to supply the VCC.
• Connect the host computer to the USB2ANY board via a USB cable.
• Connect the ribbon cable between the USB2ANY board and the TLC6C5716-Q1 EVM board.
Figure 2. TLC6C5724-Q1EVM Hardware Setup