Device Configuration
4
SLAU809 – June 2019
Copyright © 2019, Texas Instruments Incorporated
TAS2110EVM User's Guide
Figure 2. Default Jumper Settings
5.2
Address Selection
TAS2110EVM is configured to respond to I
2
C address 0x98 (8-bit). However, in the end application it may
be configured to one of four addresses shown in section 8.3.2 of the TAS2110 Datasheet. If desired, the
address may be changed on the EVM by configuring R18,R19,R20, and R35 as needed.
5.3
EVM Setup
Use the following instructions to complete a typical USB driven setup:
1. Install PPC3 with the TAS2110 plug-in
2. Connect a speaker to J10 on the TAS2110EVM
