Texas Instruments SWRU294, User Manual, Page: 35 / 57

SWRU294
Page 35/40
10.2.3 Silk print
Silk print text “IO” and “RF” near board current measurement jumpers P10 and P15 were on EB
revision 1.3.0 placed next to the wrong jumper. This has been corrected as seen in Figure 27.
Silk print text “MCLK” and “SMCLK” near test points TP6 and TP7 were on EB revision 1.3.0
swapped, and placed next to the wrong test point. This has been corrected as seen in Figure 27.
Figure 27
– Correct silk print for MCLK and SMCLK test points
Silk print has been added to the backside for EB revision 1.5.0. The silk print indicates the
orientation of the accelerometer axes (see section 10.2.1) and power source jumper
configurations (see section 6.3).
10.3 USB MCU pin-out
Same as revision 1.3.0, see section 9.3.
10.4 MSP430 MCU pin-out
Same as revision 1.3.0, see section 9.4.