Texas Instruments SN65LVPE512, User Manual

Page: 3 / 13

www.ti.com
PCB Construction
Table 1. Configuration of EVM (continued)
Switch Pin Description Switch Position and Corresponding Setting
SW9 Power source selection 1: 3.3 V from Regulator
2: N/A (two position switch)
3: VCC from external source on JMP1
SW10 NC N/A
Table 2. Suggested Default Settings
Switch Pin Description Switch Position and Corresponding Setting
SW1 DE1 (De-emphasis channel 1) 2: 0 dB
SW2 EQ1 (Equalization channel 1) 2: 0 dB
SW3 OS1 (Output swing channel 1) 2: 1241 mVpp
SW4 DE2 (De-emphasis channel 2) 2: 0 dB
SW5 EQ2 (Equalization channel 2) 2: 0 dB
SW6 OS2 (Output swing channel 2) 2: 1241 mVpp
SW7 EN_RXD 1: Enabled
SW9 Power source selection 1: 3.3 V from USB VBUS
SW10 NC N/A
4 PCB Construction
This section contains the EVM board schematics and the PCB board layouts.
4.1 EVM Board Schematics
Figure 1 through Figure 4 illustrate the SN65LVPE512 EVM schematics.
Figure 1. Schematic of High Speed Pins
3 SLLU213 – February 2015 SN65LVPE512 EVM
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated